Sin-Can Inc.
Air/Gas Filtration:
» Air/Gas Filter Cartridges
• Steam & Sterile Filter Cartridges
• Filtertech Filter Cartridges
• Dryers & Condensate Treatment
Air/Gas Filter Cartridges
Design and Applications
We offer a complete range of Zander filter cartridges with integrated prefiltration, including high end units. High end filters suggest a large pleated surface in combination with a maximum cavity volume of 96%. This provides for a very low differential pressure which cuts operating costs.
The unique four-phase pleated element design is effective in trapping particulate and residual moisture to 0.01 micron and residual oil to 0.005 ppm at 99.9999% efficiency while providing the longest service life (compared with traditional rolled elements) and lowest cost of operation in the business.
A tie rod construction guarantees firmly secured elements, even with pulsating system pressures. Therefore self-releasing end caps (as with conventional elements) are excluded. Another advantage is the use of coalescing media and top-quality stainless steel support cylinders inside and outside.
| Filter Type | Applications |
| Series V | Pre-filters for separating coarse particles |
| Ecomist Series | For general purpose protection against particles, oil and water |
| Series Z, ZP | Fine filters for separating oil, water, and particles |
| Series X, XP | Ultra-fine filter for separating oil, water, and particles |
| Series XP4 | Super-ultra-fine filters for separating oil, water, and particles |
| Series ZLV | Paint-compatible fine filters for separating particles |
| Series XLV | Paint-compatible ultra-fine filters for separating particles |
| Series A | Activated carbon layer for separating oil vapour and aerosols |
| Series KTA | Cartridge with activated carbon adsorbents for separating oil vapour/spray, elimination of odours, taste substances, etc. |
Benefits
• Due to unique pleating technology Zander filter elements are very economical to operate and
maintain as compared with conventional wrapped filters. For example, a 200 HP compressor with a pleated filter will save about $1200/year on energy
if a differential pressure is reduced by 3 PSI (based on 8000 running hours/year and $0.075/kWh). Besides, a lower operating pressure diminishes wear and
maintenance of the compressor itself.
• Up to 60% longer filter element service life.
• You can also benefit from Zander quality in almost all other manufactures' housings: Ultrafilter, Hankison, Walker, Deltech, Hiross, Domnick
Hunter. Please refer to interchangeability tables.
Specification
| Filter Type | Description |
| Series V | The prefilter range mainly takes out particles from the compressed air. The microfilter features a long service life with constant efficiency. The efficiency is 99.99% of all particles of 3 micron and larger. There are fine particles smaller than 3 micron, such as dust and especially oil aerosols; they need to be filtered out by a fine coalescing filter. |
| Ecomist Series | Removes particles down to 1 micron, including water and oil, providing a maximum remaining aerosol content of 0.5 ppm. |
| Series Z | Efficiency 99.99% at 1 micron. Oil retention down to approximately 0.5 ppm at 100 psig and 68°F (20°C). |
| Series Y | Efficiency 99.99% at 0.01 micron. Oil retention down to approximately 0.1 ppm at 100 psig and 68°F (20°C). |
| Series X | Efficiency 99.9999% at 0.01 micron. Oil retention down to approximately 0.01 ppm at 100 psig and 68°F (20°C). Performance is validated. If an even better quality of compressed air to remove the oil vapours, then an adsorption type filter is required. |
| Series A | Incorporates an activated carbon adsorption bed together with an integrated dust filter. Vapour removal to 0.005 ppm at 100 psig and 68°F (20°C). It is always preceded by a microfilter series XP to remove oil aerosols. |
| Series ZP | Efficiency 99.9999% at 1 micron. Oil retention is 0.5 ppm at 100 psig and 68°F (20°C). |
| Series XP | Efficiency 99.99999% at 0.01 micron. Oil retention is 0.01 ppm at 100 psig and 68°F (20°C). If an even better quality of compressed air to remove the oil vapours, then an adsorption type filter is required. |
| Series XP4 | Efficiency 99.99999% at 0.01 micron. Oil retention is 0.001 ppm at 100 psig and 68°F (20°C). |
Further information
Please see interchangeability tables for Zander filter cartridges that can replace other manufactures' filters, or contact us for help and current prices.
Phone (403) 287-2345 • Toll-free 1-(800)-565-2345 • Fax (403) 287-1355 • E-mail: sincaninc@telus.net
© 2006 Sin-Can Inc. All rights reserved.